This version of the TARDIS was introduced in the 1976 story ‘The Masque of Mandragora’ at the beginning of the fourteenth season. By that point the original TARDIS prop was too battered to survive.

The new TARDIS was designed by Barry Newberry and was wider than its predecessor with a flatter roof. The text on the door panel was white on blue. There were some occasional changes to the lamp but this version remained in use for four years until the story ‘Horns of the Nimon’.

Our model was built by Gavin Rymill. It is 1:21 scale (to go with The Doctor Who Figurine Collection) and stands 132 mm tall to the top of the lamp.

The original TARDIS prop was modified in “The War Games” and this version was used throughout the Third Doctor’s stories and for the Fourth Doctor's first two seasons. Various repairs were made during this time, most notably, it was given a fresh coat of paint. The original prop was eventually retired in 1976, meaning it had been in service for 13 years.

The model is 1:21 scale to match the Eaglemoss figurines and stands 12.9 cm tall.

LIMITED EDITION • WEBSITE EXCLUSIVE

In ‘The Happiness Patrol’ the Doctor and Ace land on the planet Terra Alpha, where sadness is against the law. In an effort to enforce joy, Helen A’s Happiness Patrol paint the TARDIS pink. After the Doctor helps with the rebellion, normal emotions are restored and the TARDIS is painted blue again.

The model is 1:21 scale to match the Eaglemoss figurines and stands 12.8 cm tall.

During the Seventh Doctor’s tenure, there were actually three different versions of the TARDIS, all of which were made of fibreglass. They were all cast from the same moulds, but there were differences to do with the frame around the sign at the top and the position of the lock and handles. These TARDIS props had doors on the front and the back. On one side, the door opened on the left; on the other side, it opened on the right.

The model is 1:21 scale to match the Eaglemoss figurines and stands 12.8 cm tall.

The original version of the TARDIS was modified at the end of the show’s third season. The design of the roof was altered so that it was flatter, and new doors were made with a new lock. This version first appeared in “The War Machines” and was used throughout the Second Doctor’s tenure. It was given a refit before “The War Games”.

The model is 1:21 scale to match the Eaglemoss figurines and stands 12.8 cm tall.

This figurine shows the Fourth Doctor as he appeared in his final story 'Pyramids of Mars' It is just over 10 cm tall.

The 2004 series of Battlestar Galactica upgraded all the elements of the show, including the Cylons themselves. The modern version of the Centurion was a fully-CG creation that took the series' effects to a new level. In the show, the Centurions were ruthless killing machines with limited intelligence and self awareness.

The statue stands 7.5 inches (19 cm) tall.

This beautiful polystone model of the standard Dalek introduced in 2005 stands 197 mm tall.

This is the first in a new line of medium-sized Daleks and is an upgrade on the smaller Daleks Eaglemoss released with a more detailed gun and glass 'ears'. At 1:8.5 scale it is the perfect size to fit on your shelves.

Figures in this collectable series are frozen in a 'Moment in Time' pose which is detailed on the collectors box.

This figure captures the Third Doctor played by actor Jon Pertwee in the classic 1973 adventure "THE GREEN DEATH". The figurine wears his classic petrol blue and red velvet blazer and black trousers, frilly shirt and bow tie, and holds his all important sonic screwdriver.

Scale 1:21, approx 84mm tall.

This stunning figure of the Dalek Battle Computer features incredible detail and is part of a collectable limited edition series of fine quality figurines.

Figures in this collectable series are frozen in a 'Moment in Time' pose which is detailed on the collectors box.

This figure depicts the Dalek as it appeared in the classic Seventh Doctor adventure from 1988 ' Remembrance of the Daleks'.

Fully BBC licensed and approved merchandise.

Part of the Rare Dalek subscriber series.

Scale 1:21, approx 78mm tall.

This is the Dalek that started it all: the original version which made its debut in the 1963 episode 'The Dead Planet'. These first Daleks were restricted to their city on Skaro and drew power through the floor, but they were every bit as deadly and evil as the Daleks that followed.

This new model was sculpted by Dalek expert Gavin Rymill and is approximately 7 inches (18 cm) tall. It is made of polystone, has a detailed gun and manipulator arm, both of which are attached by magnets, and in an upgrade on previous models it has transparent 'ears'.

Ships Mid November

Rose Tyler, played by Billie Piper, is one of the Doctor's defining companions. She met the Ninth Doctor shortly after the end of the Time War and joined him in the TARDIS. She saved the world from a Dalek invasion by absorbing vortex energy and becoming the 'Bad Wolf'. She continued to travel with the Tenth Doctor, and was eventually trapped in a parallel universe with a version of the Doctor hat was created in a meta crisis. She is shown here with the Tenth Doctor in 'The Stolen Earth'. The Doctor is roughly 10 cm tall and Rose is 9 cm.

This is the version of the Dalek which appeared in the first season after Doctor Who returned in 2005. It is subtly different from the Dalek that appeared earlier in the season, with some changes to the painting and it went on to become the definitive take on the Daleks. The figurine is 8 cm tall.

In the original Battlestar Galactica Muffit was a robotic recreation of Boxey's pet daggit, which was killed during the Cylon attack. Despite being a robot, Muffit had a real personality, occasionally getting into trouble and saving the day.

This is one of the very few BSG statues that Eaglemoss produced. It stands just over 4.25 inches (11 cm) tall.

Figures in this collectable series are frozen in a 'Moment in Time' pose which is detailed on the collectors box.

This stunning figure of the 12th Doctor Peter Capaldi features incredible detail and is part of a collectable limited edition series of fine quality figurines.

highly detailed metallic resin figurine has been crafted and painted by hand, and shows the Twelfth Doctor from the episode 'Flatline' as he steps out of his TARDIS in his dark blue Crombie suit with red check lining and Paul Smith trousers, brogues and he wears a signet ring on his ring finger.

The Twelfth Doctor is shown as he appeared in the episode “FLATLINE”

Scale 1:21, approx 84mm tall.

LIMITED EDITION. This extraordinary display case features a complete set of 1:21 figurines of all 17 Doctors in an acrylic TARDIS shelving unit that is designed to be fixed to a wall. A panel on the front (where the doors are) can be removed to reveal the Doctors inside. The display itself is an impressive 81 cm tall by 46 cm across.

Figures in this collectable series are frozen in a 'Moment in Time' pose which is detailed on the collectors box.

The dapper Fifth Doctor is depicted as he appeared at the end of the Black Guardian trilogy, in the episode “ENLIGHTENMENT”

It features the Doctor in his cricketing jacket and jumper, striped trousers, and even includes little details such as the question marks on his collar and stick of celery on his lapel.

Scale 1:21, approx 84mm tall.

Figures in this collectable series are frozen in a 'Moment in Time' pose which is detailed on the collectors box.

A little bit crazy but even more heroic, this Doctor could find the fun in anything, but his passion to fight evil ran deep as his love for his friends.

The Eleventh Doctor is shown as he appeared in the episode “THE PANDORICA OPENS”

Scale 1:21, approx 84mm tall.

This stunning figure of the Death Zone Dalek features incredible detail and is part of a collectable limited edition series of fine quality figurines. This was part of Eaglemoss's series of rare Daleks.